4"x10" Black Steel Floor Register, Walkable Heavy-Duty Louvered Vent Cover with Damper

The old floor register was showing its age after many years of sitting in front of the deck slider. I thought the Handua Floor Register would provide a suitable replacement and it did. I chose black over the old off-white just for a change.This floor register seems well constructed. The louvers open and close smoothly. What more is there?

I ordered this to replace one of my floor registers that had been damaged. I know floor registers are not fancy or glamorous items so there isn't a whole lot to say in this review. It fits perfectly (be sure to measure correctly - the size listed is for the opening size) and it is easy to slide the lever open and closed. It is walked on regularly by my family and animals and is holding up well.

I have been renovating my bathroom and decided to move the heating vent from the floor to a wall I'm putting in. I know this vent says it is for the floor, but I thought I would be able to make it work in a wall and it was the right measurements so I took a chance. I have not finished my install yet (since I still have a lot of other work I need to do first) but I did a test fit and everything looks perfect. There are a few things worth noting though if you are considering this product.First, It is a floor register. It will fit in any 3.25"x10" duct, but getting it to stay in place is another issue. Most wall or ceiling registers have screws on the front that will hold it in place. This one does not and does not have holes for any such screws. I haven't figured it all out for my situation yet, but I figure if I absolutely have to, I can drill a couple holes to fasten it to the wall. I would prefer not to go that route though because I like the nice clean look of it.Second, The adjustable flow part of this particular register is one flap that opens and closes. Most bigger registers have two or more that overlap and cut off the air flow, this one is just one fin that kind of blocks most of the air. It will not block it all so don't expect it to. Also, the one that I received was pretty stiff to open and close. After inspecting it closely, I noticed the fin part was slightly bent (a pretty common issue with a lot of these type of products) and I was able to straighten it out with some needle nose pliers and a bit of careful maneuvering. If you have to do that, be careful not to scratch the finish. Once straightened, the flap opens and closes a little easier, but still not quite as easily as I would expect. This is why I took one star off my review.Finally, when the flap is fully open, there is still a little bit of an angle to it so you'll want to be aware of that when you install it. This will make a difference in how the air flows. You may have to look down the duct to see which way it bends or decide if you want the air directed towards or away from a wall. In my situation, the air duct is pretty narrow so if I install it one way it will cut off most the air flow whereas if I install it the other way, it will work with the movement and allow the air to flow into the room nicely. Worst case scenario, you'll just have to test it and then switch it if you don't like the way it's working. The vent will fit in the duct equally well regardless of how it's facing.I think that's about it. Overall, I think this is a pretty good quality compared to the standard builders grade products most homes have. It's not prefect, but for the price, it's very reasonable and pretty much what I expected. Make sure you double check the size of the hole because they come in many different sizes.